What is the efficiency of a CPV cell in direct sunlight (without the concentrator)?

What is the efficiency of a CPV cell in direct sunlight (without the concentrator)?

I have seen some cpv panels on sale, for example on ebay, that say that they have around 37% efficiency, and the charts look like that efficiency gets higher under a lower amount of suns, as high as 43% or so. However, I can't find in the chart anything that says their efficiency under direct sunlight, and I understand that they are expensive but I was wondering if anyone had any information of their efficiency under a single sun (without a concentrator). I believe that these cells may also be known as triple junction and are usually 1cm2.

submitted by /u/joshglen
[visit reddit] [comments] https://ift.tt/2VdFwVA

Comments

Post a Comment

Popular posts from this blog

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices.

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices. submitted by /u/GAEA_Research [visit reddit] [comments] https://ift.tt/2tS3l9b
Read more

Aurora Inverter giving E050 error randomly

Aurora Inverter giving E050 error randomly The message requires a reset to get the inverter working again, but it's random - may happen a couple times a day, may skip a day or two. I have checked every connection, and even inside the inverter where the DC gets connected (2 arrays running). I tried turning off each array independently, but it continued for both lines at the same frequency. The only possible point of spark generation would be the connector box on the roof, which has wirenuts from the arrays themselves to the cable to the inverter. They are tight, but I went ahead and wrapped them with silicon tape (didn't help). Could the inverter itself have a problem? It is an Aurora PVI-3.0-OUTD-US and I can't find anything else in their manual. submitted by /u/Oliver_Dibble [visit reddit] [comments] https://ift.tt/2IrhYav
Read more