Just finished my standing seam roof and now looking to have the solar installed - anything I should look out for?

Just finished my standing seam roof and now looking to have the solar installed - anything I should look out for?

I think I may be a little particular about the solar panel design since I don't want the panels to:

  1. Penetrate my new roof.
  2. Look too ugly. I know some of that can't be prevented.

​

Any suggestions on how to deal with my solar contractor?

submitted by /u/jackalooz
[visit reddit] [comments] https://ift.tt/2Ssi3hH

Comments

Post a Comment

Popular posts from this blog

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices.

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices. submitted by /u/GAEA_Research [visit reddit] [comments] https://ift.tt/2tS3l9b
Read more

Aurora Inverter giving E050 error randomly

Aurora Inverter giving E050 error randomly The message requires a reset to get the inverter working again, but it's random - may happen a couple times a day, may skip a day or two. I have checked every connection, and even inside the inverter where the DC gets connected (2 arrays running). I tried turning off each array independently, but it continued for both lines at the same frequency. The only possible point of spark generation would be the connector box on the roof, which has wirenuts from the arrays themselves to the cable to the inverter. They are tight, but I went ahead and wrapped them with silicon tape (didn't help). Could the inverter itself have a problem? It is an Aurora PVI-3.0-OUTD-US and I can't find anything else in their manual. submitted by /u/Oliver_Dibble [visit reddit] [comments] https://ift.tt/2IrhYav
Read more