Just bought a small RavPower 24w USB solar charger—should it start charging right away if ~80% of it is covered in direct sunlight?—or does it need 100% direct sunlight?

Just bought a small RavPower 24w USB solar charger—should it start charging right away if ~80% of it is covered in direct sunlight?—or does it need 100% direct sunlight?

I bought a solar charger. I tried charging a battery bank right away with the charger was on my car dash. The dash was very sunny and the charger was probably ~80% covered in sunlight.

Will most chargers put out some charge in that condition?

I also tried in 100% sunlight and no devices were charging...

submitted by /u/skillDOTbuild
[visit reddit] [comments] http://ift.tt/2zHpDMg

Comments

Post a Comment

Popular posts from this blog

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices.

GAEA Research demonstrates their new energy technology called RSET. It sets the benchmark in high density, clean energy generation. Chief Scientist, Nigel C. Cheese, states the device collects Background Stellar Radiation via a RPP (Radiant Power Panel) offering compatibility to traditional devices. submitted by /u/GAEA_Research [visit reddit] [comments] https://ift.tt/2tS3l9b
Read more

Aurora Inverter giving E050 error randomly

Aurora Inverter giving E050 error randomly The message requires a reset to get the inverter working again, but it's random - may happen a couple times a day, may skip a day or two. I have checked every connection, and even inside the inverter where the DC gets connected (2 arrays running). I tried turning off each array independently, but it continued for both lines at the same frequency. The only possible point of spark generation would be the connector box on the roof, which has wirenuts from the arrays themselves to the cable to the inverter. They are tight, but I went ahead and wrapped them with silicon tape (didn't help). Could the inverter itself have a problem? It is an Aurora PVI-3.0-OUTD-US and I can't find anything else in their manual. submitted by /u/Oliver_Dibble [visit reddit] [comments] https://ift.tt/2IrhYav
Read more